The relay era is over. One module connects everything — your lights, your logic, your command. No noise. No wasted battery. Just instant authority, from a distance.
Complete System
01 — Module
The brain of the system. Compact, solid, silent. Houses the ACC circuit and wireless receiver. No relays — no noise. Wiring harness pre-routed and labeled for a clean, professional install.
02 — Connectors
Spring-loaded lever connectors. No crimping, no soldering, no guesswork. Push, click, done. Your lights connect directly — any Pulsator strobe plugs straight in and is ready to run in minutes.
03 — Remote
Soft-touch housing. Silicone buttons — no hard plastic where your fingers go. Designed for gloved hands in the dark. Command your lights from a distance, silently, without leaving the vehicle.
Engineering Philosophy
Loud relays clicking every time you switch patterns. Cheap plastic vibrating on your dashboard. That's the old way. The Pulsator Strobe Module eliminates all of it. Solid-state switching — zero mechanical noise, zero click, zero rattle. You activate it and the only thing you hear is silence.
Solid-State — No Relay Click
Traditional relay modules click audibly every switching cycle. The Pulsator Strobe Module uses solid-state control — completely silent at every pattern change, every flash, every time.
ACC Circuit — Zero Battery Drain
Built-in ACC detection. The module only draws power when your vehicle is running. Turn off the ignition — the system cuts automatically. Your battery stays full, always.
Aluminium Everywhere It Counts
We minimise plastic wherever we can. Metal where it matters — aluminium housing, aluminium construction, built to the same standard as the lights it controls.
The Remote
This is not an afterthought remote. Soft-touch housing — the kind you want to hold, even in the dark, even in gloves. Silicone buttons with tactile feedback. No hard plastic where your fingers make contact. Every surface considered.
Why Pulsator Wins
Loud relays are done. Solid-state control means zero mechanical noise at every pattern cycle, every single time. Operate completely undetected if you need to.
RF remote control reaches far. Activate your lights before you step out. Command patterns from outside the vehicle. Range that matches real operational scenarios.
The module reads your ignition signal. Power cuts the moment the engine stops — no accidental drain, no dead battery in the morning. Set it up once, forget it.
Cars, vans, trucks, SUVs — one module powers them all. DC 12V to 24V input handles any vehicle electrical system. No adapters, no converters, no fuss.
Installation
Everything is ready before it leaves the box. Pre-wired harness, labeled connectors, tool-free plug-in. Pick any Pulsator strobe product, plug it into the module, and your full system is live. No electrician, no wiring diagrams, no half-day install.
Mount the Module
Find a spot in your cab or behind the grille. Compact footprint fits anywhere. Secure with the included hardware.
Connect to ACC + Power
Two wires — one to ACC, one to the battery. Spring connectors: push and click. No tools, no crimping.
Plug In Your Pulsator Light
Any Pulsator strobe connects directly. The output connector matches — just plug in and your system is complete.
Pick Up the Remote
Pair is instant. Switch on. Select your pattern. You're operational.
Become a Dealer or Fleet Partner