Custom-grade LED chip behind a precision optical projection lens. Aluminum alloy threaded heat dissipation. Five diameters from 18mm to 30mm. IP67 sealed from −30°C to +100°C.
Pricing on Inquiry
Collect what you need, then send it as one request. This is a quote request — not an order, and no payment is taken.
Choose an option above to add this to your basket.
Works Together
The Mini Projector is a strobe head — it needs a flash controller to run patterns. The Pulsator Strobe Module is the one built for it: any Pulsator strobe plugs straight into its lever connectors. No crimping, no soldering, no wiring diagram.
Not required, and you rarely need more than one. The Mini Projector is compatible with standard flash controllers, and a single module runs several heads on the same vehicle. Add one only if you want the matched system.
Preview every Pulsator flash pattern live — eight mini-projector lamps on a Land Cruiser 300 grille. Pick a mode, watch it fire, choose your authority.
Open Flash Pattern DesignerDurability Proven
Engineering Detail
Direct-projection optical lens. Not diffused — a focused beam at distance. Flush with grille, invisible until activated.
Aluminum alloy with threaded fin architecture. Every groove accelerates thermal transfer. Sustained full-power output without throttling.
Impact-resistant and corrosion-resistant. −30°C to +100°C. Full submersion rated. Monsoon, pressure wash, Arctic freeze — seal holds.
Five diameters 18–30mm to match any grille gap. Mounts flush behind bars, completely concealed at rest. Auxiliary brightness for low beam and fog.
Technical Data
Installation
Measure your grille gap. Choose from 18, 20, 22, 25, or 30mm. The projector should sit flush — no protrusion, no gap.
Position behind the grille bar with the optical lens facing forward. Completely invisible from outside — zero visual signature at rest.
Connect to DC 12V–24V. Full output from cold start at −30°C — no warmup, no delay.
Also in the Pulsator Line
Fleet, Dealer or Direct Order
